Topic
4 replies Latest Post - ‏2013-01-24T14:04:41Z by ENO2010
ENO2010
ENO2010
12 Posts
ACCEPTED ANSWER

Pinned topic Debug tool

‏2013-01-22T09:40:23Z |
Hi,

I tried to use the RDz 8.5.1 debugger to debug my COBOL Program but I received the next error message on the RD&T console :

14.24.20 JOB00675  +EQA9999E - Debug Tool TCPIP error 14.24.20 JOB00675  +EQA9999E - +Communications Failure allocating session 14.24.20 JOB00675  +EQA9999E - Debug Tool TCPIP error


How can I solved this problem

thanks

Eric
Updated on 2013-01-24T14:04:41Z at 2013-01-24T14:04:41Z by ENO2010
  • SystemAdmin
    SystemAdmin
    253 Posts
    ACCEPTED ANSWER

    Re: Debug tool

    ‏2013-01-22T10:30:21Z  in response to ENO2010
    These are very generic messages informing that Debug Tool has not been able to reach the client.
    I would check :
    - TCP/IP address set for debugging in submitted job number JOB00675. Make sure you can ping this address.
    - Are there any firewalls in the workstation where RDz is installed? If we have firewalls you must allow the port number being used by Debug Tool (default 8001).
    • ENO2010
      ENO2010
      12 Posts
      ACCEPTED ANSWER

      Re: Debug tool

      ‏2013-01-22T12:50:51Z  in response to SystemAdmin
      I was running RDz in Virtual machine. I resinstall RDz on my workstation directly and now it's working fine.
      I need to check my VMware in order to understand why it isn't working. The firewall was disable on my VmWare.

      Eric
      • RDzJohn
        RDzJohn
        229 Posts
        ACCEPTED ANSWER

        Re: Debug tool

        ‏2013-01-22T13:11:41Z  in response to ENO2010
        fyi...RD&T is not supported running in a virtual machine.

        RDzJohn
        • ENO2010
          ENO2010
          12 Posts
          ACCEPTED ANSWER

          Re: Debug tool

          ‏2013-01-24T14:04:41Z  in response to RDzJohn
          RD&T is not installed in a virtual machine but RDZ Client was running from a VmWare.