CICS Explorer works fine with our WUI's, but when I try to set up a region to accept a login, it fails, as stated in the title. All the CO* and CWXN transactions needed are set up for use. Tried the DFH$WUTC TCPIP service with both authenticate NO and BASIC.
CICS/TS 4.2, CICS Explorer 18.104.22.168
This topic has been locked.
3 replies Latest Post - 2013-01-17T15:27:42Z by vica
Pinned topic Getting "Forbidden: DFHWU4301" on single region login
Answered question This question has been answered.
Unanswered question This question has not been answered yet.
Updated on 2013-01-17T15:27:42Z at 2013-01-17T15:27:42Z by vica
Re: Getting "Forbidden: DFHWU4301" on single region login2013-01-17T14:59:46Z in response to SystemAdminMy experience has been that if a region is being managed by CPSM, there is no way to connect the CICS Explorer directly to the region. You must manage the region through the Explorer's connection to the WUI. I suppose there's really no need to be able to connect directly to a managed region.
With that said, I really wish you were given a better message than just "Forbidden". Heck -- how difficult could it be to simply return a message that says the region is managed & therefore you must connect to the WUI.
vica 2700002CYK6 PostsACCEPTED ANSWER
Re: Getting "Forbidden: DFHWU4301" on single region login2013-01-17T15:27:42Z in response to SystemAdminHmm interesting I thought that worked? Has the region been given the setup that it needs to connect directly, did you enable TCPIP in the region and define a unique port in TCPIPS for the single region? If you used the CICS supplied definition it uses port 1490 if that port is already being used for the CPSM connection to the WUI Server perhaps that is causing the issue.