Topic
IC4NOTICE: developerWorks Community will be offline May 29-30, 2015 while we upgrade to the latest version of IBM Connections. For more information, read our upgrade FAQ.
1 reply Latest Post - ‏2013-03-07T06:20:39Z by SystemAdmin
SystemAdmin
SystemAdmin
238 Posts
ACCEPTED ANSWER

Pinned topic Implementing Appliance: Runtime is stuck at "Starting"

‏2013-01-11T11:58:13Z |
I'm setting up a new appliance and get the following when I run "System show status"

System: UP
Network: UP
Runtime: Starting

I realize that this indicates there is a problem with the application, but any pointers on where to start checking and how to check (commands) would be useful.

I'm good on the WMC side of Cast Iron, but in-experienced on the CLI, at present I can not get into the WMC, I assume because it is not UP.

Many Thanks
Updated on 2013-03-07T06:20:39Z at 2013-03-07T06:20:39Z by SystemAdmin
  • SystemAdmin
    SystemAdmin
    238 Posts
    ACCEPTED ANSWER

    Re: Implementing Appliance: Runtime is stuck at "Starting"

    ‏2013-03-07T06:20:39Z  in response to SystemAdmin
    Hi, I am stuck at the same issue. Any pointers to move forward pl. in case you were able to resolve?

    Regards,
    ND