Topic
  • 1 reply
  • Latest Post - ‏2013-03-07T06:20:39Z by SystemAdmin
SystemAdmin
SystemAdmin
238 Posts

Pinned topic Implementing Appliance: Runtime is stuck at "Starting"

‏2013-01-11T11:58:13Z |
I'm setting up a new appliance and get the following when I run "System show status"

System: UP
Network: UP
Runtime: Starting

I realize that this indicates there is a problem with the application, but any pointers on where to start checking and how to check (commands) would be useful.

I'm good on the WMC side of Cast Iron, but in-experienced on the CLI, at present I can not get into the WMC, I assume because it is not UP.

Many Thanks
Updated on 2013-03-07T06:20:39Z at 2013-03-07T06:20:39Z by SystemAdmin
  • SystemAdmin
    SystemAdmin
    238 Posts

    Re: Implementing Appliance: Runtime is stuck at "Starting"

    ‏2013-03-07T06:20:39Z  
    Hi, I am stuck at the same issue. Any pointers to move forward pl. in case you were able to resolve?

    Regards,
    ND