Topic
No replies
SystemAdmin
SystemAdmin
3234 Posts
ACCEPTED ANSWER

Pinned topic Blade Center 8886 "an error on i/o module 3,4 was detected"

‏2013-01-08T10:16:21Z |
Hi!

I have an bladecenter s , mt 8886

I receive this error:
in AMM, System status indicates:
"An error on I/O Module 3 was detected"
"An error on I/O Module 4 was detected"
and all blades lost connection to both storage modules
(hard disk from storage module don not appear on the blade server)

In AMM from IO Module task,from admin/power/restart,
I restart module 3 and module 4
and after restart
System status indicates "System is operating normally. All monitored parameters are OK."
but connection from all blades server to both storage module is not present again
(hard disk from storage module don not appear on the blade server)
Affter 2-3 minutes
System status indicates again:
An error on I/O Module 3 was detected
An error on I/O Module 4 was detected

I atached AMM service data.

Any solutions ?

Thanks!