Topic
  • 4 replies
  • Latest Post - ‏2013-01-02T21:48:20Z by SystemAdmin
SystemAdmin
SystemAdmin
6772 Posts

Pinned topic Reset the installation date through GUI ... battery ...

‏2013-01-02T18:08:43Z |
Hi

show battery returns the installation date of the battery
service battery-installed restarts the battery lifecycle clock

You can check the state of the battery using:
co
test hardware
exit

http://www-01.ibm.com/support/docview.wss?uid=swg21322505#commands
Can we do this through GUI ? --Thanks!
Updated on 2013-01-02T21:48:20Z at 2013-01-02T21:48:20Z by SystemAdmin
  • SystemAdmin
    SystemAdmin
    6772 Posts

    Re: Reset the installation date through GUI ... battery ...

    ‏2013-01-02T20:17:39Z  
    You can view the battery status under the system status options. It is different depending upon your firmware version. After 4.0, just search for "battery". For 3.x or earlier, I think it is Status -> System -> Battery (if my memory serves).
  • SystemAdmin
    SystemAdmin
    6772 Posts

    Re: Reset the installation date through GUI ... battery ...

    ‏2013-01-02T20:23:32Z  
    You can view the battery status under the system status options. It is different depending upon your firmware version. After 4.0, just search for "battery". For 3.x or earlier, I think it is Status -> System -> Battery (if my memory serves).
    Thanks for your response!
    that is for the status ...
    we were looking for restting the insatlltion date of battery --Thanks!
  • swlinn
    swlinn
    1348 Posts

    Re: Reset the installation date through GUI ... battery ...

    ‏2013-01-02T21:41:50Z  
    Thanks for your response!
    that is for the status ...
    we were looking for restting the insatlltion date of battery --Thanks!
    service battery-installed is the CLI command to reset the battery install date. I'm not aware of a web-GUI equivalent.

    Regards,
    Steve
  • SystemAdmin
    SystemAdmin
    6772 Posts

    Re: Reset the installation date through GUI ... battery ...

    ‏2013-01-02T21:48:20Z  
    • swlinn
    • ‏2013-01-02T21:41:50Z
    service battery-installed is the CLI command to reset the battery install date. I'm not aware of a web-GUI equivalent.

    Regards,
    Steve
    Yes Steve. We're trying to reset the battery insatlltion date which is part of installtion of a battery.
    So was trying to see if we can do through GUI. Looks like we cannot. Thanks!