Topic
  • 2 replies
  • Latest Post - ‏2012-12-24T08:50:34Z by SystemAdmin
SystemAdmin
SystemAdmin
6772 Posts

Pinned topic SoapAction in webserviceproxy

‏2012-12-19T11:18:59Z |
how do I decrypt the soap request in wsp operation level rule using soapaction???

I am sending the encrypted soap request to wsp. I have added the soapAction header with the value of particular operation name. In wsdl also i specified the same soapAction name. i want to decrypt this request in operation level rule. but it is showing the following error in
fsh...

source-http (calculator_FSH): No WS-Proxy service endpoints match operation in SOAP request as required by WS-I BP1.0/1.1 R2744 or R2745.
Updated on 2012-12-24T08:50:34Z at 2012-12-24T08:50:34Z by SystemAdmin
  • msiebler
    msiebler
    140 Posts

    Re: SoapAction in webserviceproxy

    ‏2012-12-19T15:03:25Z  
    You cannot do it that way. Note that a fsh can be used by >1 WS-p; For the device to match the request to the right ws-p it has to first decrypt the message even before the request rule is run; so the decryption is not configured in the policy but rather in the service.
  • SystemAdmin
    SystemAdmin
    6772 Posts

    Re: SoapAction in webserviceproxy

    ‏2012-12-24T08:50:34Z  
    • msiebler
    • ‏2012-12-19T15:03:25Z
    You cannot do it that way. Note that a fsh can be used by >1 WS-p; For the device to match the request to the right ws-p it has to first decrypt the message even before the request rule is run; so the decryption is not configured in the policy but rather in the service.
    thankyou for your reply...

    decryption is working fine as you said. but i didn't mention any decrypt key in the service.
    how it's working? how the datapower automatically takes the key from itself??