NOTICE: developerWorks Community will be offline May 29-30, 2015 while we upgrade to the latest version of IBM Connections. For more information, read our upgrade FAQ.
This topic has been locked.
3 replies Latest Post - 2012-12-05T09:28:08Z by HermannSW
Pinned topic HTTP Frontside Handler reuse across MPGW in same Domain
Answered question This question has been answered.
Unanswered question This question has not been answered yet.
It seems I can no longer leverage the same HTTP FSH across different MPGW in the same domain. Is this a recent change in v5 of firmware? It seems we use to be able to do this...am I missing something?
Updated on 2012-12-05T09:28:08Z at 2012-12-05T09:28:08Z by HermannSW
msiebler 2700005RPQ140 Posts
SystemAdmin 110000D4XK6772 PostsACCEPTED ANSWER
Re: HTTP Frontside Handler reuse across MPGW in same Domain2012-12-05T01:31:59Z in response to msieblerMulti-Protocol Gateway status: down - Failed to install on port
This message indicates the failure to install a service on the configured local network port. The op-state of the service is down and it is not accepting new connections. The most likely cause is either an invalid local address, invalid host alias or due to a conflict with another service already installed on the configured network port. Verify that the service is installed on an unused network port. Verify that the local address is configured and/or the Host Alias exists and its op-state is up.
Maybe its only reuse across WSP...and not allowed in MPGW...
HermannSW 2700006U544487 PostsACCEPTED ANSWER
Re: HTTP Frontside Handler reuse across MPGW in same Domain2012-12-05T09:28:08Z in response to SystemAdmin> Maybe its only reuse across WSP...and not allowed in MPGW...
that's it -- reuse of FSHs is only possible in WSPs.
Reusing FSHs for MPGWs will get the quickest MPGW in upstate, all others will be down.
And after domain restart even the outcome (which MPGW will be up) may be different.