Topic
  • 1 reply
  • Latest Post - ‏2012-12-06T09:00:54Z by SystemAdmin
dpdeveloper
dpdeveloper
111 Posts

Pinned topic Single Input, Multiple outputs using WTX map

‏2012-12-04T04:55:37Z |
Hi,

I have requirement where single Input (XML) and multiple outputs using WTX dpa file. When I have test this MAP in WTX its working fine and giving multiple outputs, but deployed the dpa file into Datapower and tested in Datapower, I can only get the first output, but not others.

Did anyone done this kind of scenario before?

I used below instructions to set the inputs/outputs to context variables

6. Define named outputs.
a. Click the Named Outputs tab.
b. Click Add.
1) Specify the name of an output that is expected by the map in the Name
field. This must be the same as a cardname in the map file.
2) Specify the name of the DataPower processing context that will contain
the output data in the Context field.
3) Click Apply.
c. Repeat the previous step to create another named output.
7. Click Apply.
When the transform completes, use this context in the next processing action in the
processing rule to send the data to the desired destination.

Does any one had done this before? Single Inputs and Multiple outputs in Datapower.

Thanks in Advance...
Updated on 2012-12-06T09:00:54Z at 2012-12-06T09:00:54Z by SystemAdmin
  • SystemAdmin
    SystemAdmin
    6772 Posts

    Re: Single Input, Multiple outputs using WTX map

    ‏2012-12-06T09:00:54Z  
    Hi,
    Basically, your steps are correct but did you set "Locate Named Inputs and Outputs" in main tab to "Explicit" ? Also, by using "Explicit" you have to set up named input as well. Then that would be all you have to do to use multiple output in a binary transformation. Let me know if it works for you.