I would like to know if it is possible to show inherited attributes in a class (this question was asked three years ago) below
and is it possible to set a value to an inherited attribute?
I am using RSA 8.0.4
Pinned topic Handling of inherited attributes in RSA 8.0.4
Answered question This question has been answered.
Unanswered question This question has not been answered yet.
Updated on 2012-12-17T22:48:00Z at 2012-12-17T22:48:00Z by SystemAdmin
SystemAdmin 110000D4XK14225 Posts
Re: Handling of inherited attributes in RSA 8.0.42012-12-17T22:48:00ZThis is the accepted answer. This is the accepted answer.I've recently encountered the same need in RSA.
Occasionally when I am doing a walkthru of a class diagram where a sub-class is used on its own, it would be nice to be able to show its complete attribute set without having to clutter the diagram with its generalizations.
Thus far, I have not found a way to enable this anywhere on the diagram properties / filter settings. I am close to concluding it cannot be done.
I am on 8.0.2