.. in the midst of a migration I noticed that the 'ccm_copy_tools' instructions for Synergy 7.2 explicitly ask for a Synergy 6.5 SP2 version to copy from .. does anyone know if that (copy tool) would work to copy Objectmake from an 6.5 SP1?
Pinned topic Copying objectmake from a 6.5SP1 into a 188.8.131.52 Synergy install
Answered question This question has been answered.
Unanswered question This question has not been answered yet.
Updated on 2012-11-30T09:51:48Z at 2012-11-30T09:51:48Z by David.Honey
David.Honey 270001UEBC176 Posts
Re: Copying objectmake from a 6.5SP1 into a 184.108.40.206 Synergy install2012-11-30T09:51:48ZThis is the accepted answer. This is the accepted answer.Hi Rudi,
I believe that there were patches made to ObjectMake in 6.5SP2 that are required. I suggest you find media for 6.5SP2 so that you are copying from the correct release.