Topic
  • 3 replies
  • Latest Post - ‏2014-05-22T19:34:32Z by U537_Moreno_Garcia
SystemAdmin
SystemAdmin
2402 Posts

Pinned topic Error 1004 with nmon analyzer 3.4.a

‏2012-10-23T02:01:46Z |
Hello,
I use a nmon analyser with last version,
nmon analyser V3.4.a
with aix6.1.7.0 TL05
  nmon -F $OUTFILE -P -M -s 30 -c 200 -t -I 0

When I run tools on my file, I receive an eror message
"execute error 1004
data couldn't be pasted because it is different the form of copy area and paste area.

When I open debug windows, I see highlight line
".Section.Copy Sheet1.Range("A1")

Any advice would be appreciated.
Updated on 2013-01-20T03:01:20Z at 2013-01-20T03:01:20Z by nagger
  • SystemAdmin
    SystemAdmin
    2402 Posts

    Re: Error 1004 with nmon analyzer 3.4.a

    ‏2013-01-17T15:23:36Z  
    Was there ever a solution for this?
  • nagger
    nagger
    1637 Posts

    Re: Error 1004 with nmon analyzer 3.4.a

    ‏2013-01-20T03:01:20Z  
    You don't state the Windows version or the Excel version - this is where the problem will be found.
    Excel new version not being compatible with Excel previous.
    Look in the nmon analyser documentation - it is in the ownload package then for enties on this forum about running in compatibility mode.

    It might also be you are using a non-USA number convention like . or , as thousand delimiters - again check the analyser docs.

    Hope this helps, remember I wrote the C program on AIX/Linux and not the analysr!, Nigel G
  • U537_Moreno_Garcia
    U537_Moreno_Garcia
    1 Post

    Re: Error 1004 with nmon analyzer 3.4.a

    ‏2014-05-22T19:34:32Z  
    • nagger
    • ‏2013-01-20T03:01:20Z
    You don't state the Windows version or the Excel version - this is where the problem will be found.
    Excel new version not being compatible with Excel previous.
    Look in the nmon analyser documentation - it is in the ownload package then for enties on this forum about running in compatibility mode.

    It might also be you are using a non-USA number convention like . or , as thousand delimiters - again check the analyser docs.

    Hope this helps, remember I wrote the C program on AIX/Linux and not the analysr!, Nigel G

    Same problem here using Windows 7 and Microsoft Excel 2007

    I'm trying to merge 7 logs (1 for each day 1.5MB each) using Merge = Yes and Top. It stops after the "Analysing Top".

    Screenshots attached

    Attachments