1 - Display Parameters/Generate DSNZPARM source, I am able to display the current ZPARMS settings successfully.
However, from this display of the ZPARMS when I change one of the parameters and let’s assume CONDBAT is
changed from 10000 to 9000 and hit PF3 I get a confirmation screen that asks me to confirm the member
replacement. I then enter a 1 in response to this question. I then get the following error:
FTINCL error occurred reading ADB2ZZSK. Return code = 20. Reason code = 0.
The second error I am encountering occurs when I choose option 2 - Assemble and Linkedit DSNZPARM module. I get the following error:
HIGH LEVEL ASSEMBLER - INTERRUPT AND DIAGNOSTIC DUMP HLASM R6.0 2012/09/11 16.12
- * ASMA999U Assembly terminated - SYNAD Exit taken - Permanent I/O error on SYSIN data set
I was logged on using RACF ID IBMUSER when I experienced these errors.
I found this reference - http://www-01.ibm.com/support/docview.wss?uid=swg1PK90881
Is it possibly related? Any advice?