Topic
  • 3 replies
  • Latest Post - ‏2012-09-17T13:32:01Z by shanz9903
Dragi
Dragi
2 Posts

Pinned topic Externally linking to a sequence diagram in Rational Rhapsody?

‏2012-09-03T13:50:08Z |
Hello,

Is it possible to make a link in Microsoft Word to a particular diagram in IBM Rational Rhapsody for Software Architect, so when someone clicks that link a specific rpy file is opened right at a desired diagram?
It is needed to refer to different diagrams throughout our document, and using a screenshot is not a good choice because every time the referred diagram is update, the Word document must be updated too

Regards,
Dragi
Updated on 2012-09-17T13:32:01Z at 2012-09-17T13:32:01Z by shanz9903
  • Vipsy
    Vipsy
    37 Posts

    Re: Externally linking to a sequence diagram in Rational Rhapsody?

    ‏2012-09-03T21:26:34Z  
    Have you considered generating documents from the model.
    You could have placeholders in the doc and have Rational Publishing Engine extract the model information into them.
  • Dragi
    Dragi
    2 Posts

    Re: Externally linking to a sequence diagram in Rational Rhapsody?

    ‏2012-09-17T10:48:48Z  
    • Vipsy
    • ‏2012-09-03T21:26:34Z
    Have you considered generating documents from the model.
    You could have placeholders in the doc and have Rational Publishing Engine extract the model information into them.
    Hello Vipsy,

    Do you know how can I use Rational Publishing Engine to extract model information into an existing Word document? I managed only to create a new document, but not to update an existing one. If you can provide me a link to a document/web page describing this, it will be great. I tried searching, I could not find this.

    Regards,
    Dragi
  • shanz9903
    shanz9903
    281 Posts

    Re: Externally linking to a sequence diagram in Rational Rhapsody?

    ‏2012-09-17T13:32:01Z  
    • Dragi
    • ‏2012-09-17T10:48:48Z
    Hello Vipsy,

    Do you know how can I use Rational Publishing Engine to extract model information into an existing Word document? I managed only to create a new document, but not to update an existing one. If you can provide me a link to a document/web page describing this, it will be great. I tried searching, I could not find this.

    Regards,
    Dragi
    https://www.ibm.com/developerworks/forums/thread.jspa?messageID=14177134&#14177134
    http://www.ibm.com/developerworks/wikis/display/rpe/Generic+Templates