Topic
IC4NOTICE: developerWorks Community will be offline May 29-30, 2015 while we upgrade to the latest version of IBM Connections. For more information, read our upgrade FAQ.
1 reply Latest Post - ‏2012-07-31T22:05:08Z by hskolwal
SystemAdmin
SystemAdmin
374 Posts
ACCEPTED ANSWER

Pinned topic How to have logical model->physical model international characters

‏2012-07-31T07:28:15Z |
Hi,

We have some international characters (ÅÄÖ, etc.) in our logical model. When transforming to physical model, the characters should be converted e.g. Ö->O. I have seen this being done automatically and it is probably a project setting. But where do I change the setup for this?
Updated on 2012-07-31T22:05:08Z at 2012-07-31T22:05:08Z by hskolwal
  • hskolwal
    hskolwal
    11 Posts
    ACCEPTED ANSWER

    Re: How to have logical model->physical model international characters

    ‏2012-07-31T22:05:08Z  in response to SystemAdmin
    So you want the logical element name to be say ÅÄÖ but the physical element name (after transformation) to be just AAO. Is that right?