I'm trying a new installation of RDz UT. After IPLing the system i am unable to connect to UT box through PCOMM (IBM Personal Communication). After giving IP and Port in PCOMM when i use to connect so it says;
"Local socket trying to connect to remote server/Host192.168.32.130 using port 3270 infinitely...."
Kindly help me out in the following error.
This topic has been locked.
6 replies Latest Post - 2012-07-26T13:42:37Z by RVXY_Shajeel_Khan
Pinned topic Trouble Connecting to z1090
Answered question This question has been answered.
Unanswered question This question has not been answered yet.
Updated on 2012-07-26T13:42:37Z at 2012-07-26T13:42:37Z by RVXY_Shajeel_Khan
RDzJohn 060000E02P255 PostsACCEPTED ANSWER
Re: Trouble Connecting to z10902012-07-24T14:14:16Z in response to RVXY_Shajeel_KhanCheck the IP address of your UT machine and ensure it is valid. Make sure that TCPIP starts cleanly with no errors on any of the interfaces. Connect PCOMM to the valid TCPIP address. If none of this makes any sense, read zPDT Redbook Vol 2 Chapter 3. Scenario 4 is the easiest to configure using a SA router/ bridge.
SystemAdmin 110000D4XK253 PostsACCEPTED ANSWER
Re: Trouble Connecting to z10902012-07-25T06:53:27Z in response to RVXY_Shajeel_KhanShajeel,
Check that TCP/IP is started, and try a ping from your workstation where you have PCOMM to the UT Box.
If this is correct, then can you please configure the PCOMM emulator so that it points to port number 23 instead of port number 3270?
JavaPoet 120000FPBH11 Posts
Re: Trouble Connecting to z10902012-07-26T13:42:37Z in response to RVXY_Shajeel_KhanHi All,
Issue Resolved, port was closed. I used this command to open the port;
"/sbin/iptables -A INPUT -m state --state NEW -m tcp -p tcp --dport 3270 -j ACCEPT"
Shajeel Ahmed Khan