Topic
3 replies Latest Post - ‏2012-06-22T19:34:06Z by jmblaise
jmblaise
jmblaise
21 Posts
ACCEPTED ANSWER

Pinned topic Is there a possibility to generate scripts from command line ?

‏2012-06-17T11:26:52Z |
Hello,

I can't use IDMT in graphical mode. I understand I can run it in -console mode, but this will generate scritps only once.

There is a geninput command that can be run to update table list. Is there a way to update scripts from command line after running geninput ?

Thanks,

JMB
Updated on 2012-06-22T19:34:06Z at 2012-06-22T19:34:06Z by jmblaise
  • nivanov1
    nivanov1
    22 Posts
    ACCEPTED ANSWER

    Re: Is there a possibility to generate scripts from command line ?

    ‏2012-06-19T17:04:19Z  in response to jmblaise
    If I understand your question correctly, you'll need to run the unload script.
    • GregWathen
      GregWathen
      13 Posts
      ACCEPTED ANSWER

      Re: Is there a possibility to generate scripts from command line ?

      ‏2012-06-19T19:51:31Z  in response to nivanov1
      Yes, nivanov1 is right. Just set GENDDL=true and the other options to false if you do not want to re-extract the data.
    • jmblaise
      jmblaise
      21 Posts
      ACCEPTED ANSWER

      Re: Is there a possibility to generate scripts from command line ?

      ‏2012-06-22T19:34:06Z  in response to nivanov1
      Hi nivanov1,

      Thanks, but my question is if I run geninput, it will generate again a new table list. Therefore the scripts derived from this file are not accurate, among them unload.

      What are the steps to have unload script regenerated after geninput has been run ? Generally, my question is what are the steps to run, in command line, the re-generation of scripts to proceed migration (DDL and Unload) in command line.

      Thanks,

      JMB