• No replies
10 Posts

Pinned topic How can I get DDL warnings from the IDMT

‏2012-04-23T06:22:16Z |
In the "Interactive Deploy" tab, there are 2 status of object: success or failed. The warning can not be seen.
In some case, it looks all succeed, but in fact not.

For example: a table is missed, then some depended procedures are successfully deployed. But after the missing table is created, the procedures will fail.
This can cause an illusion that everything is OK, but when you run the procedures, you will down. So, I think it is better to display the warning infomation.

Anyone can help?