Small doubt: WMQFTE does reliable transfer.
Q1) So in case during file transfer process if any issues comes up where does the data stays ?
Q2) If the data stays what is the maximum amount of size it could be ?
This topic has been locked.
2 replies Latest Post - 2012-03-06T15:50:01Z by R_Simons
Pinned topic WMQFTE File Transfer Fail
Answered question This question has been answered.
Unanswered question This question has not been answered yet.
Updated on 2012-03-06T15:50:01Z at 2012-03-06T15:50:01Z by R_Simons
Bruce_Olsen 100000T1J81 PostACCEPTED ANSWER
Re: WMQFTE File Transfer Fail2012-03-05T20:26:19Z in response to SystemAdminYou're transfering a file. During the transfer, the file is read, WMQFTE keeps track of how much has been sent. In the event a restart is needed, it will start where it has to to maintain the integrity of the file. So the short answer to Q1 is the file is where it is when the transfer started. The answer to Q2 is that it depends on how large your file system is and can it hold all the files you have ready to transfer.
R_Simons 27000167KS11 PostsACCEPTED ANSWER
Re: WMQFTE File Transfer Fail2012-03-06T15:50:01Z in response to SystemAdminTo add to the other post:
Q1 - data is held in multiple locations. As the file is read on the sending system, it is parsed into messages and put to the receiving agents "data" queue. up to the maximum amount of inflight data (determined by the chunk, frame and window size parameters set) As the receiving agent gets the messages, it starts rebuilding the file on the local file system. And as these messages are written successfully, status message go back to the source agent to send more data. So depending upon the state of the WMQ environment file data will be present on the sending file system, source agent's QM transmit queue, receiving agent's data queue and the receiving agent's file system.
Q2 - See the chunk, frame and window agent.properties parameters. These govern the amount of "in flight" data PER TRANSFER
All of this is described in the Info Center.