Topic
  • 4 replies
  • Latest Post - ‏2012-03-01T09:25:22Z by SystemAdmin
SystemAdmin
SystemAdmin
430 Posts

Pinned topic ITNM 3.8: Create Maps with all Critical devices

‏2012-02-07T08:54:16Z |
Hello,
I am trying to create a map in ITNM 3.8 with all nodes that received a Critical event.

Any of you has any tip about which filter shall be used in this case?

Thanks

Fabio
Updated on 2012-03-01T09:25:22Z at 2012-03-01T09:25:22Z by SystemAdmin
  • jstanson
    jstanson
    32 Posts

    Re: ITNM 3.8: Create Maps with all Critical devices

    ‏2012-02-07T12:05:07Z  
    Hello Fabio,

    You might consider an event-based view using the activeEvent table. Here's what you can try:

    Create a view.
    Select Type = Filtered
    Switch to the Filter tab.
    In the Table field, select activeEvent.
    In the Filter field, click on the Open Filter Builder icon. This brings up a Filter Builder panel.
    In the Field field, select Severity.
    In the Value field, select Critical.

    Good luck,
    Janusz
  • SystemAdmin
    SystemAdmin
    430 Posts

    Re: ITNM 3.8: Create Maps with all Critical devices

    ‏2012-02-07T12:56:11Z  
    Hi,
    thanks for the answer.

    Unfortunately, from what I can see from this document

    http://www.ibm.com/developerworks/forums/thread.jspa?messageID=14786719

    such behaviour has been introduced in ITNM 3.9 so I need to upgrade first to new release
    before having such view.
    Do any of you know know if this behaviour has been designed for ITNM3.8 too (as fixpack or similar)?
    Regards

    Fabio
  • SystemAdmin
    SystemAdmin
    430 Posts

    Re: ITNM 3.8: Create Maps with all Critical devices

    ‏2012-03-01T06:52:10Z  
    Hi,
    thanks for the answer.

    Unfortunately, from what I can see from this document

    http://www.ibm.com/developerworks/forums/thread.jspa?messageID=14786719

    such behaviour has been introduced in ITNM 3.9 so I need to upgrade first to new release
    before having such view.
    Do any of you know know if this behaviour has been designed for ITNM3.8 too (as fixpack or similar)?
    Regards

    Fabio
    Hi Fabio,

    This feature is available in 3.9 and future version only not in 3.8.

    Thanks,
    Mani.
  • SystemAdmin
    SystemAdmin
    430 Posts

    Re: ITNM 3.8: Create Maps with all Critical devices

    ‏2012-03-01T09:25:22Z  
    OK, I'll wait for 3.9 installation then..
    thanks a lot for your support !

    Fabio