Topic
2 replies Latest Post - ‏2011-11-14T13:23:27Z by jscheel
hxman
hxman
2 Posts
ACCEPTED ANSWER

Pinned topic RHEL 5.7 and IBM Network Interfaces

‏2011-11-13T15:46:29Z |
Hello,

I am new to RHEL but have over 15 years of Solaris and AIX knowledge and starting to get up to speed with RHEL installs.

I recently installed RHEL 5.7 on an IBM JS23x blade and noticed I have 6 interfaces, but the blade only has 2 physical ports. I assume these are virtual interfaces. Can I get rid of them and just plumb the 2 standard interfaces?

What's the deal here?.. lol
Updated on 2011-11-14T13:23:27Z at 2011-11-14T13:23:27Z by jscheel
  • hxman
    hxman
    2 Posts
    ACCEPTED ANSWER

    Re: RHEL 5.7 and IBM Network Interfaces

    ‏2011-11-13T16:46:42Z  in response to hxman
    Additional hardware setup:
    Blade Center S
    1 x Cisco 3012
    6 x JS23x Blades
    2 x SAS I/O Cards
  • jscheel
    jscheel
    31 Posts
    ACCEPTED ANSWER

    Re: RHEL 5.7 and IBM Network Interfaces

    ‏2011-11-14T13:23:27Z  in response to hxman
    The IBM Power Linux Team is migrating to a new developerWorks Community - Think Power Linux. If you'd join us in this new community and post your question to the Message Board, we'll gladly respond.

    Thanks!