I am trying to create a base OS images
In line with the instructions on pg 22 of the manual I created a 'clean' instance of SLES 11 (32 bit).
a) Using putty I copied the file aebundle.zip to the directory /tmp.
b) I unziped the content to /tmp/cloud.
c) I used chmod 755 *.sh to set the right access levels.
d) I run ./IconImageSynchronizer.sh
This resulted in the following errors:
linux:/cloud # ./IconImageSynchronizer.sh
BEGIN Roll Your Own customization: Automation
ENTER task: task
ENTER step: New Step
.ZIP.or ae1.zipfind or open ae1.zip
: command not founde 2:
failed: No such file or directory1-0.8.el5.noarch.rpm
: command not founde 4:
failed: No such file or directoryarch.rpm
: command not founde 6:
tar: aereset.tar: Cannot open: No such file or directory
tar: Error is not recoverable: exiting now
: command not founde 8:
cp: cannot stat `base.al': No such file or directory
: command not founde 10:
activation.ConfigLicense 0:off 1:off 2:off 3:on 4:off 5:on 6:off
activation.ConfigLocale 0:off 1:off 2:off 3:on 4:off 5:on 6:off
activation.ConfigNET 0:off 1:off 2:off 3:on 4:off 5:on 6:off
activation.ConfigPWD_ROOT 0:off 1:off 2:off 3:on 4:off 5:on 6:off
activation.ConfigPWD_USER 0:off 1:off 2:off 3:on 4:off 5:on 6:off
activation.ConfigSSH 0:off 1:off 2:off 3:on 4:off 5:on 6:off
activation.ConfigVNC 0:off 1:off 2:off 3:on 4:off 5:on 6:off
activation.ConfigNTP 0:off 1:off 2:off 3:on 4:off 5:on 6:off
: command not founde 12:
ERROR: step execution failed: New Step
This topic has been locked.
1 reply Latest Post - 2012-06-07T14:11:36Z by JeromeVercoutere
Pinned topic Installation of IBM Activation Engine bundles in SLES 11 fails.
Answered question This question has been answered.
Unanswered question This question has not been answered yet.
Updated on 2012-06-07T14:11:36Z at 2012-06-07T14:11:36Z by JeromeVercoutere
JeromeVercoutere 2700056FCY1 PostACCEPTED ANSWER
Re: Installation of IBM Activation Engine bundles in SLES 11 fails.2012-06-07T14:11:36Z in response to JBrandsmaI already had the problems.
You can check if the file are correctly transfer from your installation folder to /tmp.
Then, you can execute manually the step describe on the aeinst.sh