Topic
6 replies Latest Post - ‏2010-07-09T11:22:33Z by DanMueller
DanMueller
DanMueller
7 Posts
ACCEPTED ANSWER

Pinned topic cannot execute dbaccess in 11.50.fc5

‏2010-07-07T19:50:33Z |
when i attempt to use dbaccess in 11.50.fc5 on aix, i get an error message that says "Cannot open file 'menukey.iem'." This on a brand new instance and sysmaster was built successfully. Any ideas?
Updated on 2010-07-09T11:22:33Z at 2010-07-09T11:22:33Z by DanMueller
  • casallig-ibmUK
    casallig-ibmUK
    3 Posts
    ACCEPTED ANSWER

    Re: cannot execute dbaccess in 11.50.fc5

    ‏2010-07-08T10:16:50Z  in response to DanMueller
    Try the following:

    • mv $INFORMIXDIR/msg/zh_tw/e008/dbised.lmk $INFORMIXDIR/msg/zh_tw/e008/dbised.lmk.org
    • cp $INFORMIXDIR/msg/en_us/0333/dbised.lmk $INFORMIXDIR/msg/zh_tw/e008
    • DanMueller
      DanMueller
      7 Posts
      ACCEPTED ANSWER

      Re: cannot execute dbaccess in 11.50.fc5

      ‏2010-07-08T13:45:17Z  in response to casallig-ibmUK
      I have no zh_tw dir under msg.
      • casallig-ibmUK
        casallig-ibmUK
        3 Posts
        ACCEPTED ANSWER

        Re: cannot execute dbaccess in 11.50.fc5

        ‏2010-07-08T14:29:27Z  in response to DanMueller
        Ok, so you have no ILS installed.

        • something wrong under <INFORMIXDIR>/msg/en_us/0333/ :-(

        Have you tried re-installing the product?????
        • DanMueller
          DanMueller
          7 Posts
          ACCEPTED ANSWER

          Re: cannot execute dbaccess in 11.50.fc5

          ‏2010-07-08T15:32:06Z  in response to casallig-ibmUK
          Other instances under this same $INFORMIXDIR work fine. I suspect this is in my environment but cannot find anything. I have compared good vs. bad env commands and still cannot find a difference that would cause this.
          • casallig-ibmUK
            casallig-ibmUK
            3 Posts
            ACCEPTED ANSWER

            Re: cannot execute dbaccess in 11.50.fc5

            ‏2010-07-09T08:54:14Z  in response to DanMueller
            You could probably get away by copying the contents of <INFORMIXDIR>/msg/en_us/0333/ from a good instance of the same version.

            But I would rather recommend to re-install the product.
  • DanMueller
    DanMueller
    7 Posts
    ACCEPTED ANSWER

    Re: cannot execute dbaccess in 11.50.fc5

    ‏2010-07-09T11:22:33Z  in response to DanMueller
    Okay, this turned out to be the PATH env. var. I originally had my $INFORMIXDIR/bin at the end of my PATH. When I moved it to the beginning, all was okay.