I'm new to UML, I've been spending a lot of time reading up on it the last few days and learning about the different diagrams. I have created classes, with associations and operations, however I haven't been able to figure out (despite a lot of trial and error) which diagram is then used to show interactions between an operation and an association(s). For example, if I have an operation that is meant to "create datafield" (where "datafield is an association within the same class as the operation).. how would I specify this interaction?
Thanks for any advice.
This topic has been locked.
2 replies Latest Post - 2010-04-21T20:52:20Z by r1010
Pinned topic Question about defining actions of operations on attributes
Answered question This question has been answered.
Unanswered question This question has not been answered yet.
Updated on 2010-04-21T20:52:20Z at 2010-04-21T20:52:20Z by r1010
Re: Question about defining actions of operations on attributes2010-04-21T20:52:20Z in response to r1010Just to add to what I asked... well, now that I just looked back over what I had been doing, I think I'm pretty sure the sequence diagram is what is used for what I was asking.. however, I guess what had been confusing me is... I don't see a way to specify an operation to act on a specific association (from within a class) in the sequence diagram.. is this possible? If not, am I overlooking something as I had thought this would be necessary.. thanks for any advice