Topic
2 replies Latest Post - ‏2010-02-24T09:12:17Z by krysno
krysno
krysno
3 Posts
ACCEPTED ANSWER

Pinned topic DataStage: multiple instance in Sequence Job

‏2010-02-22T19:19:38Z |
In the "Job Sequence" I used multiple call Job (parallel) with the parameters
"Allow multiple instance" - enabled
error messages in the second call "Job is not in the right state (compiled and not running)"

if it is not possible to call the same Job in sequence?
Updated on 2010-02-24T09:12:17Z at 2010-02-24T09:12:17Z by krysno
  • LenGreenwood
    LenGreenwood
    19 Posts
    ACCEPTED ANSWER

    Re: DataStage: multiple instance in Sequence Job

    ‏2010-02-23T08:23:36Z  in response to krysno
    You have to give a different invocation id to each instance of a job that you want to run at the same time. The Job Activity properties page in the sequence will have a field headed "Invocation id" if the job being called had "Allow multiple instance" enabled when it was compiled. Try setting that field to 2 different strings.
    • krysno
      krysno
      3 Posts
      ACCEPTED ANSWER

      Re: DataStage: multiple instance in Sequence Job

      ‏2010-02-24T09:12:17Z  in response to LenGreenwood
      Thanks, this is it. Job running ok.