Topic
3 replies Latest Post - ‏2012-12-12T22:55:43Z by kimbert@uk.ibm.com
SystemAdmin
SystemAdmin
4179 Posts
ACCEPTED ANSWER

Pinned topic Getting vector index out of range error

‏2008-06-20T15:49:20Z |
I tried to deploy a messsage set which as XML Schema. I am getting the following error.

"BIP5502E: A Common Parser Interface internal error occurred: Diagnostic information: CheckedVector::error - vector index out of range..
An internal error occurred while reading from or writing to the bitstream.
If the problem persists, please contact your IBM support center."

The Schema has one top level aggregate and more than 12 child level aggregated. Each child level aggregates has more sub child aggregates.It was working fine till 10 child level aggregates.
Could anyone please help.

Thanks.
Updated on 2012-12-12T22:55:43Z at 2012-12-12T22:55:43Z by kimbert@uk.ibm.com
  • SystemAdmin
    SystemAdmin
    4179 Posts
    ACCEPTED ANSWER

    Re: Getting vector index out of range error

    ‏2008-06-20T16:44:44Z  in response to SystemAdmin
    Please ignore the previous message I posted. Problem solved. There was a problem with the XML Schema. One of the element type was not defined and I changed all unbounded to specific limit.

    Thanks,
    • SystemAdmin
      SystemAdmin
      4179 Posts
      ACCEPTED ANSWER

      Re: Getting vector index out of range error

      ‏2012-12-12T05:49:26Z  in response to SystemAdmin
      Please let me how you fixed the issue, as I am also facing similar issue.
  • kimbert@uk.ibm.com
    kimbert@uk.ibm.com
    467 Posts
    ACCEPTED ANSWER

    Re: Getting vector index out of range error

    ‏2012-12-12T22:55:43Z  in response to SystemAdmin
    This is actually an internal error in the MRM parser. You could open a PMR, or you could re-check your message definitions and make sure that you have not made any obvious mistakes.