Topic
1 reply Latest Post - ‏2014-05-01T17:37:05Z by Rouffa
EdVillarreal
EdVillarreal
1 Post
ACCEPTED ANSWER

Pinned topic Failed - Incomplete Array

‏2014-04-15T18:37:27Z |

I have attached a word document that helped be bring online a 'failed and incomplete' array.  I had a power outage on one of my DS4800 disk enclosures and this put about 10 arrays out of commission.  When power was restored, the arrays came back saying 'failed - incomplete array'.  Of course it's always better to engage IBM technical assistance so with that being said, hope this helps!

 

  • Rouffa
    Rouffa
    6 Posts
    ACCEPTED ANSWER

    Re: Failed - Incomplete Array

    ‏2014-05-01T17:37:05Z  in response to EdVillarreal

    sorry but normally you should run serial command vdmshowoopieces to find time stamp and disk failure sequence

    usually with power failure all disks fail at same time but needs to be sure.

    the revive all disks and do rebuild just for the last one

    user has to check data during rebuilding...