Am I wrong?
We want to use "Document flags". It works fine in an unsecure collection, but it doesn't work in a secure collection: I see the flags, and if I try to set a flag - nothing happens ...
In "Default Application User Privileges" the "Manage documents flags"is checked.
Same behavior on 2 systems, so I think perhaps it is a "systematic thing".
Pinned topic Document flags
Am I wrong?
DanOBrien 270005JUDM1 Post
Re: Document flags2013-07-12T11:31:45ZThis is the accepted answer. This is the accepted answer.
I tried to reproduce your problem but cannot. I created a secure collection and could manipulate the document flags without a problem. What you are describing sounds like the flags are not fully included in the index yet. Can you try the following steps:
- Create collection with security and document flags enabled
- Create a crawler
- Create some document flags (also make sure the 'Enable document Flags' checkbox is selected)
- Perform a full re-crawl
- Start a full index rebuild and wait until this stops. Also this may cause the indexer to re-index. If so, wait until this finishes
- Log into the search UI and the flags should be visible and fully functional
If you have any questions let me know.
kossi 10000000BC13 Posts
Re: Document flags2013-07-30T12:28:11ZThis is the accepted answer. This is the accepted answer.
sorry, I was on vacation.
We had a PMR, and the solution is: cause we made the flags later (after the first crawl) we need a recrawl to get the flags. Now it works.
My step 1 was different than yours (document flags disabled). Some weeks later I would have the flags, and then I need the recrawl.
MichaelUpdated on 2013-07-30T12:28:29Z at 2013-07-30T12:28:29Z by kossi