Topic
3 replies Latest Post - ‏2013-06-07T07:55:19Z by DanXtrate
renauld.cedric
renauld.cedric
17 Posts
ACCEPTED ANSWER

Pinned topic EN2092 + V7000 Node iSCSI

‏2013-04-30T10:48:10Z |

Hi, all

 

Anybody know if it's possible to have 2 x EN2092 1 Go Eth to connect a V7000 Storage Node in iSCSI protocole ?

Thanks

Updated on 2013-04-30T10:56:31Z at 2013-04-30T10:56:31Z by renauld.cedric
  • gez
    gez
    4 Posts
    ACCEPTED ANSWER

    Re: EN2092 + V7000 Node iSCSI

    ‏2013-05-15T17:56:01Z  in response to renauld.cedric

    According to the Flex interop guide the V7000 requires 10G switches.

    • renauld.cedric
      renauld.cedric
      17 Posts
      ACCEPTED ANSWER

      Re: EN2092 + V7000 Node iSCSI

      ‏2013-05-16T09:02:33Z  in response to gez

      Hi,

      Not sure about this have you the reference documentation ?

  • DanXtrate
    DanXtrate
    3 Posts
    ACCEPTED ANSWER

    Re: EN2092 + V7000 Node iSCSI

    ‏2013-06-07T07:55:19Z  in response to renauld.cedric

    If you use the 2076-1xx v7000 you should have no problem, but i think you would need a software initiator on the server side. 

    the 2076-1xx comes with two 1Gbit iSCSI ports per node by default. These are the same ports as the management ones.