Executing netstat Find command parameter under IBM Rational Integration Tester (RIT) results in "Exit Code = 1" error
Rajeshavanthi 2700022MCX Visits (1201)
Recently, while working on IBM Rational Integration tester v8.5.1, an attempt was made to execute a few windows "Run" command parameters such as netstat –e | find “Bytes”. Interestingly, when you execute the windows "Find" command, you notice both the Standard Output and Standard Error sections reporting no output data. Thereby resulting Exit code = 1 error.
Following are the set of actions performed under RIT:
However when the same command parameter is executed outside RIT, on a windows command line, you should see the following kind of output.