Recovering a Failed VIO Disk
sbodily 100000RUAA Comments (10) Visits (14091)
server. It assumes the client partitions have mirrored (virtual) disks. The
recovery involves both the VIO server and its client partitions. However,
it is non disruptive for the client partitions (no downtime), and may be
non disruptive on the VIO server (depending on disk configuration). This
procedure does not apply to Raid5 or SAN disk failures.
The test system had two VIO servers and an AIX client. The AIX client had two
virtual disks (one disk from each VIO server). The two virtual disks
were mirrored in the client using AIX's mirrorvg. (The procedure would be
the same on a single VIO server with two disks.)
The software levels were:
I simulated the disk failure by removing the client LV on one VIO server. The
padmin commands to simulate the failure were:
This caused "hdisk1" on the AIX client to go "missing" ("lsvg -p rootvg"....The
"lspv" will not show disk failure...only the disk status at the last boot..)
The recovery steps included:
The "replacepv" command assigns hdisk2 to the volume group, rebuilds the mirror, and
then removes hdisk1 from the volume group.
As always, be sure to test this procedure before using in production.