From the Maximo Support Desk - Guide to Using the Report Downtime Action on Asset records
TomRichardson 0600021RN4 Visits (6561)
Here is a usage guideline for reporting Asset downtime in the Maximo Assets application via the Report Downtime action.
The intended usage of the Report Downtime function is outlined in the following statements and examples. The inclusion of this functionality in Maximo is to enhance the accuracy and usefulness of asset downtime reporting, and to provide the best possible cost analysis, auditing, and decision-making criteria. The points indicated below are all integral to these results, and are based on observations of actual client environments.
1. Create a Single Work Order for Each Single Instance of Downtime or Stoppage:
If the same asset becomes broken again, anytime after the above work has been complete, and after it was returned to service, a new Work Order should get created and the same procedures should be followed. It would not be accurate, nor can an accurate assessment of the asset performance, cost of operation, or reliability be made. Additionally, correct safety and industry-specific auditing becomes compromised when this process is not followed.
If the same Work Order is kept open through multiple occasions of breakdown, and this same Work Order is kept open to continually report downtime for the same Asset, then the observation can be made that this asset has only broken down once, since it has only generated one Work Order. This could potentially result in an unreliable and unsafe asset, that is continually causing expenses through materials and labor cost, will be left in operation.
Note: (on the Report Downtime Dialog):
2. Start Date:
3. End Date :
4. Multiple records and instances of downtime can be reported for the same Asset on the same Work Order but none of the records can have overlapping time periods.
No downtime record can be entered that has a Start Time that is earlier than another record’s End Time; conversely, no End Time can be entered that is greater than the Start Time of an existing record)
5. The downtime history can be viewed from the Asset record via Select Action | View Asset Downtime History
6. The values in the Start Time and End Time fields can be edited but may be automatically changed in some circumstances, and will remain as the permanent values if they are not noticed and/or changed by the user:
If the user attempts to enter a time that is in the future, it may change from PM to AM to conform to the business logic. An example of this is that if it is 3:00 PM, and the user is entering a value of 4:00 PM (which is a future time), then the system will attempt to correct the value to an allowed value, of 4:00 AM
Tom Richardson is an IBM Maximo Support Engineer and frequent contributor to the Asset Management Blog community. For a complete index of links to his articles, visit