IBM System Storage SAN Volume Controller (SVC)
JeffHebert 060001UEQ2 Tags:  ssd disk range iaas mid storage enterprise ibm v7000 svc 3,949 Views
“Procedures for replacing or adding nodes to an existing cluster”
Scope and Objectives
The scope of this document is two fold. The first section provides a procedure for replacing existing nodes in a SVC cluster non-disruptively. For example, the current cluster consists of two 2145-8F4 nodes and the desire is to replace them with two 2145-CF8 nodes maintaining the cluster size at two nodes. The second section provides a procedure to add nodes to an existing cluster to expand the cluster to support additional workload. For example, the current cluster consists of two 2145-8G4 nodes and the desire is to grow it to a four node cluster by adding two 2145-CF8 nodes.
The objective of this document is to provide greater detail on the steps required to perform the above procedures then is currently available in the SVC Software Installation and Configuration Guide, SC23-6628, located at www.ibm.com/storage/support/2145. In addition, it provides important information to assist the person performing the procedures to avoid problems while following the various steps.
Section 1: Procedure to replace existing SVC nodes non-disruptively
You can replace SAN Volume Controller 2145-8F2, 2145-8F4, 2145-8G4, and 2145-8A4 nodes with SAN Volume Controller 2145-CF8 nodes in an existing, active cluster without taking an outage on the SVC or on your host applications. In fact you can use this procedure to replace any model node with a different model node as long as the SVC software level supports that particular node model type. For example, you might want to replace a 2145-8F2 node in a test environment with a 2145-8G4 node previously in production that just got replaced by a new 2145-CF8 node.
Note: If you are attempting to replace existing 2145-4F2 nodes with new 2145-CF8 nodes do not use this procedure as you must use the procedure specifically for this sort of upgrade located at the following URL:
This procedure does not require changes to your SAN environment because the new node being installed uses the same worldwide node name (WWNN) as the node you are replacing. Since SVC uses this to generate the unique worldwide port name (WWPN), no SAN zoning or disk controller LUN masking changes are required. READ MORE>