Setting Ports to obtain ITM TEP Charts in TBSM
mibravo 120000FUKA Visits (4718)
Being able to obtain TEP Charts in TBSM is a useful function, but setting up the ports might be a little daunting. There are a couple of things to remember. The default ports used by the TEPS in 623 changed:
For the ITM Chart Service to work, the port must be specified in 2 ways on TBSM. The most obvious is using the TBSM TIP GUI. Here is a screen print of the GUI panel where the TEPS port is specified:
In addition, you must specify a CLI command as well:
Run the following command:
If you still have problems, you should check that the ports are not being blocked by a firewall.