When you install a WebSphere Message Broker agent (KQI) V730 FP2 and you are using IIB10.0.x, you need to follow the instructions given here:
Anyway even if the broker is discovered and the workspace tree is created, all the workspaces remain grey.
If this happens there is a chance that you are using the wrong kqi agent binary.
Generally speaking you need to apply the instructions given in 7.3.0-TIV-XEforMsg-FP0001 Readme file.
The agent needs to load some WebSphere MQ libraries when it starts to monitor V10 brokers.
If your environment already has WebSphere MQ installed, set the WebSphere MQ library path like you did for previous versions.
If there is no WebSphere MQ installed, you must use another binary file instead of the kqiagent file:
-- On UNIX systems, backup <agent_install_path>/<arch_code>/qi/bin/kqiagent file and rename the kqiagt10 file to kqiagent by completing
the following steps. The kqiagt10 file is located in the same directory with the kqiagent file.
mv kqiagent kqiagent.bak
mv kqiagt10 kqiagent
-- On Windows systems, backup the kqiagent.exe file and rename the kqiagt10.exe file to kqiagent.exe. Do not use underscore character '_' to
backup the kqiagent.exe since it might be recognised as kqiagent_<instance name>.exe. The kqiagent.exe and kqiagt10.exe files are located
in the following directories:
32-bit agent: <agent_install_path>\TMAITM6\
64-bit agent: <agent_install_path>\TMAITM6_x64\
For example, you can do it by running the following command in the command prompt:
rename kqiagent.exe kqiagent.exe.bak
rename kqiagt10.exe kqiagent.exe
Remember: The kqiagt10 file is for IBM Integration Bus V10 only. Use it only when there is no WebSphere MQ installed. Otherwise, always use the
default binary kqiagent file.
The binary kqiagt10 is for the broker without queue manager, but your broker may use a queue manager and if this is the case, then you should use the original binary kqiagent to monitor broker.
Refer to 7.3.0-TIV-XEforMsg-FP0001 Readme file.
Please perform the following steps.
Stop QI agent if it is active.
Run the commands:
cd < ITMHome>/< arch>/qi/bin
mv kqiagent kqiagt10
mv kqiagent.bak kqiagent
Start QI agent.