Control and indicator diagrams - Netfinity 5600

Resolving The Problem

The most commonly used controls and indicators on the front of the server appear in the following illustrations.





1 - Operator Information Panel: The lights on this panel give status information for the server. See Operator information panel for more information.
2 - Diskette-Eject Button: Press this button to eject a diskette from the drive.
3 - Diskette Drive In-Use Light: When this light is on, the diskette drive is being accessed.
4 - CD-ROM Eject/Load Button: Press this button to eject or retract the CD-ROM tray so that you can insert or remove a CD.
5 - Hard Disk Status Light: Each of the hot-swap drive bays has a Hard Disk Status light. When this amber light is on continuously, the drive has failed. When the light flashes slowly (one flash per second), the drive is being rebuilt. When the light flashes rapidly (three flashes per second), the controller is identifying the drive.
6 - Hard Disk Activity Light: Each of the hot-swap drive bays has a Hard Disk Activity light. When this green light is flashing, the drive is being accessed.
7 - Cover Release Lever: Use this lever to release the left-side cover on the tower model or the top cover on the rack model.
8 - Reset Button: Press this button to reset the server and run the power-on self-test (POST).
9 - Power Control Button: Press this button to manually turn the server on or off.
 

 
The server can be activated in several ways:

• You can turn on the server by pressing the Power Control button on the front of the server.

• If the server is activated and a power failure occurs, the server will start automatically when power is restored.
• The server can also be powered on by the Netfinity Advanced System Management Processor.

• You can turn off the server by pressing the Power Control button on the front of the server. Pressing the Power Control button starts an orderly shutdown of the operating system, if this feature is supported by the operating system, and places the server in standby mode.

• You can press and hold the Power Control button for more than 4 seconds to cause an immediate shutdown of the server and place the server in standby mode. This feature can be used if the operating system hangs.
• You can disconnect the server power cords from the electrical outlets to shut off all power to the server.

10 - CD-ROM Drive In-Use Light: When this light is on, the CD-ROM drive is being accessed.
11 - CD-ROM Manual Tray-Release Opening: Insert a straightened paper clip in the opening to release the CD-ROM tray when using the CD-ROM eject button is not successful.