Image catalog recovery

If you used an image catalog to install IBM® i software, follow these procedures to determine where the failure occurred and the appropriate recovery action.

The following table lists the error messages that could occur if you are using an image catalog to install.

Table 1. Image Catalog Verification Recovery
Message	Description
CPF9897 CPDBD1E	Cause (Reason code 01): The load-source disk unit must have at least 2000 MB of free storage space to be able to install from an image catalog (virtual media device). Recovery: To determine if you have enough free space available, see Freeing up space on the load-source disk unit for an image catalog. Perform the procedure for freeing up space on the load-source disk unit and try your request again. The topic, Cleaning up disk storage space, contains the procedure. Cause (Reason code 02): Installation of the release requires additional allocation of space for License Internal Code. Recovery: Follow the directions in the error message. More information is in the topic, Required: Allocating additional space for Licensed Internal Code. Cause (Reason code 03): The Licensed Internal Code media is not supported for installation over the current version, release, and modification that is installed or for your system model. Recovery: Try your request again with a supported release.
CPF3DE5	Cause: The Licensed Internal Code and IBM i software agreements have not been accepted. Recovery: Perform the steps Required: Accepting software agreements.
CPD4F23	Cause: The release is not supported on this server model. Recovery: Specify a supported release or server model. Then try the request again.
CPD4F1C	Cause: One or more PTFs on the system are delayed PTFs and require an IPL action. An installation from virtual media cannot be done when delayed PTFs exist. Recovery: Perform an unattended IPL, then retry your request