Deploying protocols on an existing cluster
Use this information to deploy protocols on an existing cluster using the installation toolkit.
- Instantiate your chef zero server using the following command.
./spectrumscale setup -s 192.168.0.1
- Designate protocol nodes in your environment to use for
the deployment using the following command.
./spectrumscale node add FQDN -p
- Designate GUI nodes in your environment to use for the
deployment using the following command.
./spectrumscale node add FQDN -g
- Configure protocols to point to a file system that will
be used as a shared root using the following command.
./spectrumscale config protocols -f FS_Name -m FS_Mountpoint
- Configure a pool of export IPs using the following command.
./spectrumscale config protocols -e Comma_Separated_List_of_Exportpool_IPs
- Enable NFS on all protocol nodes using the following command.
./spectrumscale enable nfs
- Enable SMB on all protocol nodes using the following command.
./spectrumscale enable smb
- Enable Object on all protocol nodes using the following
command.
./spectrumscale enable object ./spectrumscale config object -au admin -ap -dp ./spectrumscale config object -e FQDN ./spectrumscale config object -f FS_Name -m FS_Mountpoint ./spectrumscale config object -o Object_Fileset
- Review the configuration prior to deployment using the
following command.
./spectrumscale config protocols ./spectrumscale config object ./spectrumscale node list
- Deploy protocols on your defined environment using the
following command.
./spectrumscale deploy --precheck ./spectrumscale deploy
After deploying protocols on an existing cluster, deploy
protocols authentication.