If a node canister
is inaccessible through your administrative network, use this procedure
to connect a personal computer directly to the node canister to access
the service assistant.
About this task
This procedure starts the initialization tool if the enclosure
is not part of a system because the following conditions are true:
- The node canister is in candidate state.
- No system details are configured.
- The partner node is not in active state.
Otherwise, this procedure starts the service assistant.
Procedure
To connect a personal computer directly to the node canister,
complete the following steps:
- Configure DHCP on the Ethernet port of the personal computer
to connect to the node canister.
If the personal computer
cannot support DHCP, configure static IPv4 address 192.168.0.2 on
the port.
- Connect an Ethernet cable between the port on the personal
computer and the technician port.
The
technician port is labeled T on the rear of
the node canister.
- Open a supported web browser on the personal computer and
browse to this URL:
http://192.168.0.1
- Complete the appropriate procedure.
- If the initialization tool opens, complete the initialization
as described in the installation procedure.
- If the service assistant dialog opens, use it to service the
node canister.
- Log out of the service assistant.
- Disconnect the Ethernet cable from the technician port.