INMNODE macro

The INMNODE macro builds a table that establishes correspondencebetween system identifiers and network node names.

For each system on which the TRANSMIT and RECEIVE commands will be executed, code the macro once.
For loosely-coupled JES3 complexes and JES2 multi-access spool complexes, code the macro two or more times specifying the same node-name but different smf-ids.
For a multiprocessor, code the macro once.
You only have to code the INMNODE macro for the host node (the node, into which, you will link-edit this copy of INMXPARM). You do not have to code an INMNODE macro for every node in the network.
If you code an INMNODE macro for nodes other than the host, and one of the other nodes has the same smf-id as the host node, assemble the INMNODE macro for the host ahead of the INMNODE macro for the node with the duplicate smf-id.

The syntax of the INMNODE macro follows.

␢   INMNODE   node-name,smf-id

node-name

The name of a network node

value:

must be one of the following:

The same as a node name you specified on the NJERMT JES3 initialization statement or on the NODE(nnnn) JES2 initialization statement, or
If you do not define a node name to JES, the default node name NODE0001 (or N001).

smf-id

The system identifier for a particular processor or a multiprocessor

value:: must be the same as a system identifier you specified in the SID parameter of the SMFPRMxx PARMLIB member

Note: If you omit the smf-id for the host node, TSO/E uses a value of eight question marks (????????) for the node-name associated with the transmitted data.