I/O Queuing Configuration Data Section

This section contains one entry per channel path, described by triplet R783CPDS in the I/O Queuing Configuration control section.

Offsets		Name	Length	Format	Description
0	0	R783CPID	1	binary	Channel path identifier.
1	1	R783CPST	1	binary	Channel path status Bit Meaning when set 0 Channel path installed 1 Channel path online 2 Channel path varied 3 Channel path offline to all devices of the LCU 4 Channel path connection to all devices of the LCU altered by VARY PATH command during interval 5 Measured channel path data incorrect 6 Channel path is DCM managed 7 CHPID manipulated, requiring data reset
2	2	R783CUN	2	binary	Number of control units attached.
4	4	R783CU1	2	binary	First control unit attached.
6	6	R783CU2	2	binary	Second control unit attached.
8	8	R783CU3	2	binary	Third control unit attached.
10	A	R783CU4	2	binary	Fourth control unit attached.
12	C	R783CUB	4	binary	Number of times control unit was busy.
16	10	R783PT	4	binary	Number of times channel path was taken.
20	14		4		Reserved.
24	18	R783DPB	4	binary	Number of times that the Director Port was busy.
28	1C	R783CBT	4	binary	Delay time of an I/O request because the control unit was busy.
32	20	R783CMR	4	binary	Initial command response time until the first command is indicated as accepted by the device.
36	24	R783SBS	4	binary	Switch busy count summation: contains the switch busy counts received for all partitions.
40	28		4		Reserved.
44	2C	R783CPXF	1	binary	Channel path extended flags Bit Meaning when set 0 Extended I/O measurement-block data available 1-7 Reserved.
45	2D	R783CPAT	1	binary	Path attributes Value Meaning 0 Not specified for this path. 1 Preferred path. 2 Non-preferred path.
46	2E		2		Reserved.