POWER7 information
PCI-X Quad-Channel Ultra320 SCSI RAID Adapter (FC 5582, 5583, 5738, 5777; CCIN 571E)
Learn about the features and specifications for the PCI-X Quad-Channel Ultra320 SCSI RAID Adapter.
Feature codes
- 571E is the custom card identification number (CCIN) on the adapter.
- 5738 is the IOP-based feature code for the adapter for the IBM® i operating system.
- 5777 is the IOPless feature code for the adapter for the IBM i operating system.
- The 5582 includes an IOP-based 5738 PCI-X Quad-Channel Ultra320 SCSI RAID Adapter and a CCIN 574F auxiliary-write cache IOA.
- The 5583 includes an IOPless, 5777 PCI-X Quad-Channel Ultra320 SCSI RAID Adapter and a CCIN 574F auxiliary-write cache IOA
Adapter features
- 64 bit, 3.3 volt
- Address support for up to 60, 16-bit SCSI physical disk drives on 4 independent internal SCSI buses. (The actual number of drives is limited by physical device placement limitations.)
- Four internal (only) U320 SCSI ports. Internally attached Ultra320 devices are designed to run at a data rate of up to 320 MB per second on systems that have internal backplanes that are capable of supporting Ultra320 speeds.
- Utilizes Low Voltage Differential (LVD) drivers and receivers. It can support single ended (SE) and LVD devices on SCSI bus 1, but LVD devices only on other SCSI busses.
- Up to 1.5 GB of compressed write cache, and up to 1.6
GB of compressed read cache
- 390 MB/1.5 GB compressed write cache.
- 415 MB/1.6 GB compressed read cache.
- Removable cache card with a concurrently maintainable battery. The removable transportable cache card can be used by service providers for cache data recovery procedures.
- Peripheral Component Interconnect-X (PCI-X) support
- RAID capability:
- Supports RAID and non-RAID DASD, tape, and optical devices.
- 0649 provides RAID 0, 10, 5, 6 capability.
- 5582 and 5583 provide RAID 5 or RAID 6 capability.
- A minimum of 3 disk drives is required for RAID 5.
- A minimum of 4 disk drives is required for RAID 6.
- 574F Auxiliary Cache IOA is required for either RAID level.
For information about using an auxiliary-write cache IOA, see ../p7hcd/fc574f.htm.
Specifications
Item | Description |
---|---|
Adapter FRU number | 42R5130 |
Cache battery FRU number | 39J5554 |
Cables | Attachment cables are included with the attaching subsystem or device. |
I/O bus architecture | PCI-X compliant |
Slot requirement | One available 3.3 volt PCI or PCI-X slot when
the disk controller adapter is used by itself. Two available 3.3 volt PCI or PCI-X slot when the disk controller adapter is used with an auxiliary-write cache adapter. |
Maximum number | For the maximum adapters supported, see the PCI adapter placement topic collection for your system. |
For details about slot priorities and placement rules, see the PCI adapter placement topic collection for your system.
Operating system or partition requirements
This adapter is supported for the following
versions of operating systems:
- AIX®
- AIX 5L™ Version 5.2 with the 5200-10 Technology Level, or later
- AIX 5L Version 5.3 with the 5300-06 Technology Level, or later
- Linux
- AIX 5L Version 5.2 with the 5200-10 Technology Level, or later
- AIX 5L Version 5.3 with the 5300-06 Technology Level, or later
- See the Linux Alert site for the support details.
- IBM i
- IBM i V5R3 and V5R3m5
- IBM i V5R4 with PTFs
Adapter side view, end view, and SCSI connectors
Figure 1. Adapter side view and end view
Figure 2. Adapter
SCSI connectors
- A
- SCSI connector 1 = bus 0
- B
- SCSI connector 2 = bus 1
- C
- SCSI connector 3 = bus 2
- D
- SCSI connector 4 = bus 3