Before you begin a stand-alone server installation with DB2® or stand-alone workstation installation
with DB2, make sure that you
complete the planning steps and meet the prerequisites. These steps
are applicable only to stand-alone installations with DB2.
About this task
A stand-alone installation with DB2 deployment
type must be done on a clean server or a clean workstation.
Procedure
- Review the readme file for system requirements and potential
issues that might affect your installation.
- Read the release notes for information about supported
product features or enhancements to the release.
- Review and complete the installation worksheets.
- Complete the Acquiring and extracting the installation files task.
- Review Installation requirements.
- Review Stand-alone installation deployment types.
- If you are installing in a Dynamic Host Configuration Protocol
(DHCP) environment, you must set the host IP in the /etc/hosts file.
This setting is not required if your host uses a static IP. This setting
is not required for custom installations either.
- For stand-alone installations with DB2, ensure that you are logged in as the root
user, assuming that IBM DB2, InfoSphere MDM,
and IBM WebSphere Application Server will
all be installed using root.
Important: To
perform installations as a root user, you must install IBM Installation
Manager in admin mode.
To install IBM Installation
Manager in
admin mode, log in as the root user, then run the install
command.
What to do next
Continue with starting your installation with LaunchPad and
use the installation instructions for your stand-alone with DB2 deployment type.