You can start or stop deployment environments based on
IBM-supplied patterns directly from the administrative console; this
action stops and starts all clusters in the deployment environment.
Before you begin
Verify that deployment environments exist on this deployment
manager. From the administrative console of the deployment manager,
click .
Required security role for this task: When
security and role-based authorization are enabled, you must log in
to the administrative console as an administrator or configurator
to perform this task.
About this task
Starting and stopping a deployment environment invokes a
stop or start operation on all the clusters in the deployment environment
at the same time, which might cause warnings or exceptions in the
systemout.log file. If the deployment environment contains multiple
clusters that depend on one another, it is recommended that you start
and stop the individual clusters in the deployment environment as
described in
Starting and stopping a cluster.
Follow
these steps when you want to start or stop a deployment environment
based on IBM-supplied patterns. If you have a custom deployment environment,
you cannot use this procedure. Instead, you must start and stop clusters
individually.
Procedure
- From the Deployment Environments page in the administrative
console, click the check boxes next to the names of the deployment
environments to start or stop.
- Take one of the actions:
Action |
Result |
Click Start. |
The deployment manager starts the clusters that make up the
deployment environments. |
Click Stop. |
The deployment manager stops the clusters that make up the
deployment environments. |
Note: This process can take several minutes
depending on the size of the deployment environment.
Results
The display refreshes to indicate the status of the deployment
environments.