IEA023E SYSCONS AUTOMATIC ACTIVATE/DEACTIVATE SUSPENDED–text.
Explanation
Text is one of the following three cases, referred to throughout this message as either Case 1, Case 2, or Case 3.
- Case 1: SYSTEM CONSOLE AUTOACT GROUP grpname IS NOT DEFINED.
- Case 2: VARY CN(syscons_name),ACTIVATE ISSUED BY OPERATOR. ISSUE VARY CN(syscons_name),DEACTIVATE TO RE-ENABLE AUTOACT PROCESSING.
- Case 3: VARY CN(syscons_name),DEACTIVATE ISSUED BY OPERATOR. ISSUE VARY CN(syscons_name),ACTIVATE TO RE_ENABLE AUTOACT PROCESSING.
Explanation for Case 1: The system console has an AUTOACT group specified, but the group is not defined in the current CNGRPxx. The system console is not be automatically placed in PD mode; it is removed from PD mode.
Explanation for Case 2: The system console has an AUTOACT group active. The system console has been put into PD mode manually. No automatic actions are taken until it is taken out of PD mode by command.
Explanation for Case 3: The system console has an AUTOACT group active. The system console has been taken out of PD mode manually. No automatic actions are taken until it is put into PD mode by command.
System action
System Action for Case 1: None.
System Action for Case 2: There is no automatic activate or deactivate of the system console. This message is deleted when the system console is deactivated by a command, or when the AUTOACT attribute is removed from the system console.
System Action for Case 3: There is no automatic activate or deactivate of the system console. This message is deleted when the system console is activated by a command, or when the AUTOACT attribute is removed from the system console.
Operator response
Operator Response for Case 1: Either issue the SET CNGRP= command to use a CNGRPxx which has the group defined, or issue VARY CN(syscons_name),AUTOACT= to change the name of the AUTOACT group. To remove the AUTOACT attribute, issue VARY CN(syscons_name),AUTOACT=*NONE*.
Operator Response for Case 2: When automatic activate/deactivate is wanted again, issue VARY CN(syscons_name),DEACTIVATE. To remove the AUTOACT attribute, issue VARY CN(syscons_name),AUTOACT=*NONE*.
Operator Response for Case 3: When automatic activate/deactivate is wanted again, issue VARY CN(syscons_name),ACTIVATE from the system console. To remove the AUTOACT attribute is removed from the system console.
System programmer response
System Programmer Response for Case 1: Correct the CONSOLxx and CNGRPxx parmlib members so that the correct members are specified.
System Programmer Response for Case 2: None.
System Programmer Response for Case 3: None.
Source
Communications task (COMMTASK)
Module
IEAVSWSC,IEECB854
Routing code
1,2,10 (also sent to the system console)
Descriptor code
11