IEA883I MODULE mmmmmmmm NOT FOUND
Explanation
During system initialization, SVC dump initialization processing cannot find a module in the link pack area (LPA), nucleus, or SYS1.LINKLIB system library. It is possible that the module is not in an APF-authorized library, which will also prevent the system from loading the module into storage.
- mmmmmmmm
- The name of the module that cannot be found.
System action
The system continues initialization. SVC dumping is impaired.
- IGC005A
- IEAVTSPR
- IEAVTSDT
- The system writes no SVC dumps.
- IEAVTSSD
- The system writes no summary dumps.
- IEAVTSDR
- The system does not process memory ends for SVC dump recovery.
- IEAVTSSV
- The system writes no suspend summary dumps.
- IEAVTSXT
- The system does not give control to the installation exits for SVC dumps.
- ISGDSDMP
- The system does not give control to the installation exits for SVC dump.
- IEAVTSEP
- The system does not give control to the installation exits after SVC dumps.
- IARQDUMP
- The system may dump excessive amounts of virtual storage.
The module name can be for an installation-provided post dump exit routine, if the exit name is specified in IEAVTSEP and the routine is not in SYS1.LINKLIB.
Operator response
Notify the system programmer of this message. If requested by the system programmer, reIPL the system.
System programmer response
Place the missing modules in the appropriate system library. In the case of LNKLST or APF changes, dynamic LNKLST or APF changes might be accomplished using SET PROG commands. Otherwise, reIPL the system to fully enable SVC dumping.
Source
SVC Dump (SDUMP)
Module
IEAVTSDI, IEAVTDSV
Routing code
10
Descriptor code
4