IEA590I WTO USER EXIT text
Explanation
An error occurred during the initialization or running of a WTO installation exit routine. text is one of the following:
- exit-name ABENDED - EXIT DEACTIVATED
- IEAVMXIT NOT FOUND
- IEAVMXIT NOT LOADED - NO STORAGE AVAILABLE
In the message text:
- exit-name ABENDED - EXIT DEACTIVATED
- The WTO installation exit abnormally ended. The system marked
it as nonexecutable. In the message text:
- exit-name
- The name of the installation exit, which can be IEAVMXIT or a user written WTO installation exit.
- IEAVMXIT NOT FOUND
- The system could not load installation exit routine IEAVMXIT from any system library.
- IEAVMXIT NOT LOADED - NO STORAGE AVAILABLE
- Storage was requested for the general WTO installation routine IEAVMXIT, but the storage was not available.
System action
The system action is one of the following:
- exit-name ABENDED - EXIT DEACTIVATED
- The system abnormally ends user exit exit-name.
- IEAVMXIT NOT FOUND
- The system does not process the CONTROL M command.
- IEAVMXIT NOT LOADED - NO STORAGE AVAILABLE
- The system does not process the CONTROL M command.
Operator response
Contact the system programmer.
System programmer response
Respond to the error messages as follows:
- exit-name ABENDED
- Enter the SET MPF=NO command to remove the erroneous exit routine, then enter the SET MPF command to invoke a correct WTO installation exit.
- IEAVMXIT ABENDED
- Enter the CONTROL M,UEXIT=N command to delete the erroneous IEAVMXIT routine, then enter the CONTROL M,UEXIT=Y command to activate the corrected IEAVMXIT routine.
- IEAVMXIT NOT FOUND
- Place the installation exit routine, IEAVMXIT, in a system library in the LNKLST concatenation.
- IEAVMXIT NOT LOADED - NO STORAGE AVAILABLE
- Increase the storage in the common service area (CSA) by changing the CSA specification in the SYSP parameter. Then reenter the CONTROL M command to activate the installation exit.
Source
Communications task (COMMTASK)
Module
CNZS1MPF and IEEMB819
Routing code
2,10
Descriptor code
4