IEA343D NUCLEUS OVERLAPS PLPA, RE-IPL OR REPLY ‘GO’ FOR COLD START

Explanation
The nucleus overlaps into the previous system queue
area/extended system queue area (SQA/ESQA) area. This causes an overlap
into the area required by pageable link pack area (PLPA) or extended
PLPA (EPLPA). This might have been caused by one of the following: The size of the nucleus increased.
The amount of central storage increased; this increase results
in an increase in the size of the nucleus.

 PLPA and EPLPA must be in the same virtual storage location
as the previous IPL for warm starts to proceed. Therefore, the quick
or warm start cannot proceed. The operator must reIPL or allow the
IPL to change to a cold start.

System action
This message requests a response from the operator.
If the operator replies GO, the system issues message IEA929I (CLPA
FORCED), changes the IPL to a cold start, and continues paging initialization.
Otherwise, the operator must reIPL.

Operator response
Determine if the correct nucleus was specified
at IPL. If not, specify the correct nucleus and reIPL. If the correct
nucleus was specified at IPL, notify the system programmer.

System programmer response
If the problem cannot be resolved,
search problem reporting data bases for a fix for the problem. If
no fix exists, contact the IBM® Support
Center.

Source
Auxiliary storage manager (ASM)

Module
ILRASRIM

Routing code
Note 9

Descriptor code
2