IEA298I MAXCAD VALUE, `xxxxxx`, NOT VALID. DEFAULT OF 50 USED

Explanation

During system initialization, an incorrect MAXCAD value was specified in one of two ways:

In the IEASYSxx parmlib member
In the operator response to message IEA101A

In the message text:

xxxxxx: The incorrect MAXCAD value

System action

Initialization continues with the default MAXCAD value of 50.

Operator response

You can reIPL to enter a correct value, but is not required.

System programmer response

Specify the MAXCAD value again by doing one of the following:

Ask the operator to enter a correct value in response to message IEA101A.
Correct the value specified in the IEASYSxx member.

Source

Supervisor control

Module

IEAVNPO9

Routing code

2,10

Descriptor code

4