IEA000I dev,err......hh.mm.ss
Explanation
The processor's error recovery procedures detected an error that requires either a CEM (CE message), or an SUU (subsystem unit unusable) message. An equipment check might occur with either CEM or SUU. Because the system WTO routine can print only one message, the error recovery procedure prints the CEM or SUU message and the system WTO routine prints the remaining message with full sense data. The error recovery procedure continues recovery action based on the error condition.
- dev
- Device number of the mass storage control.
- err
- Description of the error. The values are as follows:
- CEM -- CE message. The Mass Storage Facility has detected an error important to the service representative.
- SUU -- Subsystem unit unusable. The Mass Storage Facility has marked one of its units as unusable because of an error condition. The SSID of that unit is in the second half of sense byte 1 and all of byte 2 in the accompanying message. The system continues processing; notify your service representative.
- hh.mm.ss
- Time that the message was received in hours, minutes, and seconds.
System action
The error recovery procedure continues the recovery action based on the error condition.
Operator response
Probable hardware error. Each message should be considered as a potential attention of a marginal condition. Depending on the installation requirements, take appropriate action.
Source
DFSMSdfp
Module
ERPs
Routing code
1
Descriptor code
12